Slope quality Rockfall Protection Mesh products are classified into active slope quality Rockfall Protection Mesh products and passive slope quality Rockfall Protection Mesh products according to the protection type of the project. The use of slope quality Rockfall Protection Mesh products in highway and railway landslides. When the buckle is used for the slope quality Rockfall Protection Mesh products, the screw must be tightened until the wire rope is flattened by about one-third and then stop. Because the wire rope is easily deformed when it is stressed, the second tightening is carried out after the wire rope is stressed to ensure the firmness of this interface.

The size of the buckle should be adapted to the thickness of the steel wire rope, because the buckle is too big and too small, it must be the same size. The net distance inside the U-shaped ring buckle is about 1~3mm larger than that of the steel wire rope. If the net distance is too large, it is not easy to clamp the rope.
The distance between the rope clips of the slope quality Rockfall Protection Mesh products is generally about 5 to 8 times the diameter of the slope quality Rockfall Protection Mesh products wire rope. The arrangement sequence must be neat, and then the U shape is clamped on the side of the rope head, and the pressure plate is placed on the side of the main rope. It should be noted that it cannot be used repeatedly.
The above is an introduction to the precautions in the use of the slope quality Rockfall Protection Mesh products buckle.