During the protection construction process of slope quality Rockfall Protection Mesh products, the construction team will first clean up the floating soil and dangerous rocks on the slope surface by building and dismantling the construction platform, and build the overall construction platform, and then the anchor construction team will construct the anchor rod from top to bottom. After the two rows of anchor rods are released, the construction team of the slope quality Rockfall Protection Mesh products will install the protective net from top to bottom. After the construction of each layer is completed, the construction team will remove the construction platform by building and dismantling the construction platform. Construction is carried out sequentially from top to bottom.
Slope quality Rockfall Protection Mesh products construction general layout principle: combined with the geographical location and construction characteristics of the project, the slope quality Rockfall Protection Mesh products are arranged in a safe, reasonable, economical, clean and civilized manner under the premise of meeting normal construction and production. Production and living sites. The production operation area is separated from the office and living area, and the scientific layout creates a good production and living environment. Occupy as little or no arable land as possible, and minimize the factors that damage the ecological environment. Satisfy basic transportation convenience, complete production, living and communication facilities requirements.

The construction requirements of the slope quality Rockfall Protection Mesh products are to drill in strict accordance with the engineer’s setting position; before drilling, a pit with a depth not less than the length of the exposed ring sleeve of the anchor rod should be drilled at the hole position before drilling. The general diameter is 2cm and the depth is 2cm. 15cm; Active slope quality Rockfall Protection Mesh products use 1.m, 2m, 3m drill pipe for construction. Active slope quality Rockfall Protection Mesh products cannot use 3m drill pipe at a time to prevent sticking and broken rods; if the drilling position is For loose rock formations, notify the engineer or supervisor to re-determine the drilling location and do not arbitrarily construct; to ensure that the drilling depth of the active slope reaches 3.2m and the drilling has been completed, clear the hole.